Case Studies — Metallurgy
Steel and metallurgy sites concentrate heavy, high-inertia loads on networks that cannot tolerate deep voltage dips: rolling mill drives, sinter and furnace fans, large blowers. The cases below document medium-voltage soft starters and active power filters installed to limit starting current, suppress harmonics from medium-frequency furnaces, and keep the melt cycle stable. Each project lists the motor rating, the starting profile actually commissioned, and the measured outcome at site. Brigoind supplies Xichi and AVIC-Tech hardware as an independent distributor, not the manufacturer, and takes responsibility for selection calculations, documentation and commissioning support.
500+ Clients / 30+ Countries / 24h RFQ Response
- Harmonics from medium-frequency furnaces tripping capacitor banks & overheating transformers
- Two Xichi XCAPF-3L/100A active power filters (APF)
voltage THD after
4%
APF rated current
100 A
- High inrush current & mechanical stress on large induced draft fan starts
- Five Xichi CMV-1000-10 10kV MV soft starters
Current limit setting
380% Ie
Start ramp time
45 s
- Pain Point : Voltage drop & protection trips on loaded pump starts
- Solution : CMV 10kV soft starter with re-tuned start parameters
voltage drop
↓ 2%
Peak start current
↓ 320 A